What is the difference between backwash and rinse

I asked that same question a week or two ago Bruce "The significant problems we face cannot be solved at the same level of thinking we were at when we created them. The rinse is important to do so that you get all of the last bits of crap washed through All times are GMT The time now is PM.

Thank you for choosing the Worldwide Koi Club! Backwashing after heavy rains, treating for algae, or when trying to clear cloudy water will keep your filter working efficiently. Abdala Wienandt Explainer. How do you vacuum and bypass the pool filter? Bypass your filter so algae doesn't flow back into your pool with vacuum to waste. Turn off the pump. Move the multiport valve to the waste setting. Turn the pump back on. Close all skimmer lines except for one. Lemuel Sanchez Mateos Explainer.

When would you use recirculate on pool filter? This setting is used to bypass the filter during certain pool cleanups and chemical treatments when you don't want the water contaminating the sand. Wai Grigorchikov Explainer. How long should you run a pool filter for? Wilbert Beinke Pundit. Why does my pool get cloudy when I vacuum it? The idea here is to vacuum up the cloudy water right OUT of your pool , because putting that much dirty water through your filter WILL NOT work and will send that dirty water right back into your pool.

Numidia Queiros Pundit. Can you backwash a pool too much? Nury Ohlen Pundit. Do you take the skimmer basket out when vacuuming? If you 're not using a vacuum plate, remove the basket inside the skimmer , and, using your hand, block the end of the water-filled hose.

Giampaolo Numair Teacher. Can you over chlorinate a pool? By changing the position of the lever on the valve you can route the water from the pump around or through your filter in different ways so that you can perform different maintenance operations on your pool water. This is the setting that provides normal pool filtration by pushing the water through the filter media sand, glass beads or D.

E that then traps any dirt and debris before the water is returned to the pool. You should backwash your filter for about minutes or until the waste water runs clean. This can usually be seen in the clear plastic sight glass on the Multiport valve. Turn the pool filter system on and allow it to rush out of the backwash port and through the backwash hose for two minutes or so until the water in the sight glass runs clear.

Rinse runs water in the same direction that normal filtering does. Backwash runs it through the sand in the opposite direction. Rinse is to clear any dirt out of the clean side of the sand before you start sending it back to the pool. When rain is heavy, pool equipment is at risk for flooding.

If flooding water threatens to submerge the pool pump , shut off power to the pool on the main panel and see if you can remove the pool pump safely and store it indoors. If a pool pump is submerged and gets waterlogged, it will need to be replaced. Backwashing Your Pool Filter Too Often Pool water washes funk and gunk out of your filter media, then exits through your filters backwash valve drain port.

Backwashing is an important part of basic pool care, but overdoing it is one of the more common pool maintenance mistakes. Rinse Cycle. The rinse cycle gets turned on immediately after the backwash cycle and lasts 30 seconds to one minute. In a sand filter , the rinse cycle allows water to flow back down through the sand to flush out any remaining dirt and debris from the filter and piping.

You do a backwash out of a pool. If the filter is not backwashed dirt and?? A good way to tell when to backwash is watch for the pressure on the input side ti increase by a few psi. Turn off your pool pump. Push the filter handle down on a push-pull valve to move it to the backwash or back flush mode. Turn the power on to your pool pump. Pull up the push-pull valve to return to the filtering mode.

Turn on the pool pump to allow the multiport filter to rinse the sand or earth.